This instruction show a guide on how to perform the crank relearn for GM Saturn vehicles.
And for more GM vehicles projects,check here:GM vehicle repair cases
GM SATIRM Crankshaft Relearn Procedures:
1.The Powertrain Control Module (PCM) uses crankshaft velocity calculations to determine engine misfire and to operate engine misfire self-diagnostics. PCM must know precisely the variation between notches on the crankshaft. PCM contains crankshaft learn procedure which learns the variation between notches on crankshaft. The crankshaft learn procedure must be reset if PCM, crankshaft, or crankshaft position sensor are replaced.
2.If crankshaft learn procedure is being performed as a result of replacing the crankshaft, reset crankshaft learn procedure using Scan Tool equipment and manufacturer’s instructions. If replacing PCM with a replacement PCM, procedure will be prompted automatically. Allow engine to idle until SERVICE light flashes. Hold engine speed between 3000-4000 RPM until light goes off after about 10-20 seconds.
NOTE: If any Diagnostic Trouble Codes (DTC) exist that relate to an engine misfire, crankshaft learn procedure will not be initiated. Any DTCs for engine misfire must be corrected before performing crankshaft learn procedure.