In this article,G-scan2 test the G-Scan2 diagnostic tool BMW DME special function on BMW 302I 2011.And for more G-scan2 diagnostic tool test report,check here:G-scan2 test report
Procedures:
Connect G-Scan2 to the BMW 320I,and the select “Diagnosis” menu and then select BMW 320I 2011 model.
After then select “DME(Digital Engine Electronic)”,click “OK” to continue
Select “Special Function”
Select “Clear adaptations”
The adaptation values can be reset in the next test step,click “F1” to start resetting adaptation values.
Then i will show you adaptation values were reset.
Switch off terminal 15 and terminal R
Wait 15 seconds until the reset adaptation values and variants are stored in the DME,then press “OK” to continue
Switch on terminal 15
Leave ignition switched on for at least 10 seconds,press “OK” to continue
Service function finished
