This is post focus on how to use AVDI Diagnostics to remove component protection U110100 for Audi A8 2015.And for more AVDI key programming,check here:AVDI Programmer Test Projects
Connect AVDI diagnostic tool to Audi A8 2015,and then select VW software.
And scan the all DTCs,you will see the U110100 Component Protection active
Back to menu to select “Special function”
Select ”Component protection”
Select “Generation 1 and 2 Calculator”,and click “Next”
This functionality allows the customer to adapt used parts on other cars.In general this requires following steps:
1.Collect the information from the car.
2.Calculate the required data for the adaptation
3.Adapt the required module.
When scan finished,select “Dash Board”click “Next”
Note:it require internet connection
And it will require 2 tokens,press “Yes” to continue
Select “Audi A6/A7/A8 2010-2018”
Please make ignition ON.If the car is keyless-hold the key on the reader coil
The procedures will take about 10 minutes,please wait
Module learned to vehicle successfully
Now you can back to clear all DTCs and then read the fault code again
Done!
For Audi repair,please check more cases here:Audi Trouble Repair Projects.