This instruction show you guide on how to replace steering angle sensor for Linde 1275 series E16 forklifts.
Preparations:
2023 Linde Service Guide LSG 5.2.2 U0278 and 5.1.2 Free Download
Procedures:
Place the steering in the straight-ahead position and switch off the truck.
Disconnect plug 3X1 from the steering angle sensor.
Unscrew screw (2) from wiring guide (3) .
Remove the steering angle sensor wire from wiring guide (3) .
Unscrew four hexagon head screws M4 (1) and remove cover (6) from the steering angle sensor.
Remove the old steering angle sensor with O-ring (5) .
Insert new steering angle sensor with O-ring (5) .
Fit steering angle sensor cover (6) , screw in four hexagon head screws M4 (1) and tighten with 3 Nm.
Insert the steering angle sensor wire into wiring guide (3) .
Screw the screw (2) into wiring guide (3) .
Connect plug 3X1 from the steering angle sensor.
Switch on the truck.
Start the diagnostic program.
Adjust the steering angle sensor using the diagnostic program.
