The procedure outlined below describes how to configure a replacement chassis angle sensor (728/E2897) on the JCB Pilemaster machine. This process does not require any additional tooling or diagnostics equipment and is carried out through the rear display service menu.
Related Contents:
WinEEM4s JCB Service Tool 2.7.2 2.6.1 Free Download
2024 JCB ServiceMaster 4 v24.6.2 Free Download for Win 10 Win11
2017 JCB Parts Plus+ and Repair Service Manual Free Download
Chassis Angle Sensor Configuration Procedure
Accessing the Rear Display Service Menu
1 Ensure the machine’s ignition is turned OFF.
2 Disconnect the mast angle sensor. The position of the mast angle sensor is shown below.
3 Ensure that all of the emergency stop buttons are ‘out’ and have not been pressed.
4 Turn the machine’s ignition ON.
5 Ensure the rear display is ON and wait for the drill information screen to show.
Note: if the rear display does not switch ON, re-check the emergency stop buttons.
6 Press and hold both the F1 and F2 buttons. Wait 5 seconds and then press the OK button whilst still holding down the F1 and F2 buttons.
7 The display should now show the service menu.
8 The menu items are selectable by pressing the UP and DOWN arrows.
9 To access an option, press the OK button.
10 To exit the menu, select “exit” and press the OK button.
Chassis Angle Sensor Configuration
1 Select “angle sensor configuration” and press the OK button.
2 A confirmation screen will show stating that the mast angle sensor must be disconnected before continuing.
3 If the mast angle sensor has been disconnected, press the F2 button and the chassis angle sensor will be configured. Pressing the F3 button will abort the process.
4 Once the sensor has been configured (or aborted), the display will return to the service menu screen.
5 Exit the service menu screen and turn the machine’s ignition OFF.
6 Re-connect the mast angle sensor.
Checking the Angle Sensors Operation
1 Turn the machine’s ignition ON and start the engine.
2 Change the display from the drill information screen to the angle information screen by pressing the UP or DOWN button.
3 Extend the stabiliser legs to full extension. The upper two segments will react to the changes in angles from the chassis angle sensor.
4 Move the boom up and down. The lower two segments will react to the changes in angles from the mast angle sensor.
5 Once the angle sensors have been confirmed as operating, return the drill end to the ‘travel’ position and retract the stabiliser legs fully.
6 Turn the engine OFF.
More repair case for JCB,please refer to:JCB Trouble Repair