How to Change Transmission Fluid/Replace Hydraulic Oil Filter for Kubota L3301 Tractor

Here is the instruction show you guide on how to change transmission fluid/replace hydraulic oil filter for Kubota L3301,L3901,L4701 tractors.

 

Preparations:

2022 Kubota Takeuchi Diagmaster v22.08.01 v4.1.2 Software Free Download
Kubota DST-i Diagnostic Adapter

Kubota EPC Spare Parts Catalogue 2021.06 Download

 

Cleaning Magnetic Filter
CAUTION
• Be sure to stop the engine before changing the oil filter cartridge.
• Allow engine to cool down sufficiently, oil can be hot and can burn.
1 Remove the drain plugs at the bottom of the transmission case and drain the oil completely into the oil pan.
2. After draining reinstall the drain plugs.
3 Remove the oil filter.
4 Wipe off metal filings from the magnetic filter with a clean rag.
5 Put a film of clean transmission oil on the rubber seal of the new filter.
6 Quickly tighten the filter until it contacts the mounting surface, then tighten it by hand an additional 1/2 turn only.
7 Fill with the new KUBOTA SUPER UDT fluid up to the upper notch on the dipstick.
8 After running the engine for a few minutes, stop the engine and check the oil level again, add oil to the prescribed level.
9 Make sure that the transmission fluid does not leak past the seal on the filter.

IMPORTANT
• To prevent serious damage to the hydraulic system, use only a KUBOTA genuine filter.
• Do not operate the tractor immediately after changing the transmission fluid.
Run the engine at medium speed for a few minutes to prevent damage to the transmission.

How to Change Transmission FluidReplace Hydraulic Oil Filter for Kubota L3301 Tractor (1)

How to Change Transmission FluidReplace Hydraulic Oil Filter for Kubota L3301 Tractor (2)

How to Change Transmission FluidReplace Hydraulic Oil Filter for Kubota L3301 Tractor (3)

How to Change Transmission FluidReplace Hydraulic Oil Filter for Kubota L3301 Tractor (4)

How to Change Transmission FluidReplace Hydraulic Oil Filter for Kubota L3301 Tractor (5)

 

Replacing Fuel Filter
1 Remove the fuel filter.
2. Put a film of clean fuel on rubber seal of new filter.
3. Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand an additional 1/2 turn only.
4. Bleed the fuel system.

How to Change Transmission FluidReplace Hydraulic Oil Filter for Kubota L3301 Tractor (6)

Cleaning Water Separator
This job should not be done in the field, but in a clean place.
1 Close the fuel valve.
2 Unscrew the retainer ring and remove the cup, and rinse the inside with kerosene.
3 Take out the element and dip it in the kerosene to rinse.
4 After cleaning, reassemble the water separator, keeping out dust and dirt.
5 Bleed the fuel system.

How to Change Transmission FluidReplace Hydraulic Oil Filter for Kubota L3301 Tractor (7)

(1) Fuel Valve
(2) Retainer Ring
(3) Cup
(4) O-ring
(5) Element
(6) Spring
(7) Red Float

How to Change Transmission FluidReplace Hydraulic Oil Filter for Kubota L3301 Tractor (8)

More repair case for Kubota,please refer to:Kubota Trouble Repair

Visited 1 times, 1 visit(s) today