This instruction show you guide on how to remove and install oil filter base for Perkins 800D series engine.
Related Contents:
Perkins EST 2024A & 2023A & 2019A Software Free Download
Perkins SPI2 2018A EPC+Service Manual Free Download
Removal Procedure
1 Use Tooling (A) to remove engine oil filter (6) from engine oil filter base (5). Refer to Operation
and Maintenance Manual, “Engine Oil and Filter- Change”.
2 Mark the orientation of engine oil filter base (5) for installation. Remove bolt (2).
Note: The engine oil filter base can be oriented in different positions.
3 Remove bolt (4) and remove engine oil filter base (5) from the cylinder block. Plug the oil galleries in the cylinder block with suitable plugs.
4 Remove O-ring seal (1) from engine oil filter base (5).
5 Remove O-ring seal (3) from bolt (4).
Installation Procedure
1 Ensure that the engine oil filter base is clean and free from damage. Clean the mating surfaces of the cylinder block.
2 Install a new O-ring seal (1) to engine oil filter base (5). Install a new O-ring seal (3) to bolt (4).
3 Position engine oil filter base (5) against the cylinder block. Install bolt (4) finger tight.
4 Ensure the correct orientation of engine oil filter base (5). Install bolt (2) finger tight.
Note: The engine oil filter base can be oriented in different positions.
5 Tighten bolt (4) to a torque of 50 N·m (37 lb ft).
Tighten bolt (2) to a torque of 11 N·m (97 lb in).
6 Install a new engine oil filter (6). Refer to Operation and Maintenance Manual, “Engine Oil and Filter – Change” for the correct procedure.
More trouble repair case for Perkins,pls refer to:Perkins Trouble Repair