This article show you guide on how to use Launch X431 PAD V to repair Audi A4 2013 steering system fault B116854 & C10ACF0 trouble code.It need perform steering angle sensor learning.For Audi repair,please check more cases here:Audi Trouble Repair Projects.
Trouble Code:
B116854:Steering Angle Sensor-No Basic Setting
C10ACF0:Steering-End Stops Not Learned
Connect Launch X431 PAD V to Audi A4 and then select “Audi”
Select “Guided Functions”
Select “Audi A4 2008>”–>2013(D)–>Sedan–>CADA 2.0I TFSI/155kW
Press “Confirm”
System Selection–>Assistance–>Power Steering–>G85-Steering Angle Sensor,Calibration
In this program the following test steps will be performed:
Calibration of G85-Steering Angle Sensor
Checking DTC Memory of Power steering control Module-J500
Checking DTC Memory of Steering Column Electronic Systems Control Module-J527
Required Auxiliary Equipment:
6485 Steering Wheel Level
Note:The Launch X431 PAD V system will guide you step-by-step
Click “Complete/Continue”
Connect the battery charger to the vehicle
Switch ignition on
Press “Complete/Continue”
Please Check DTC Memory:
The DTC Memory of the power steering control module-J500
Store No Malfunction requiring a calibration.
Click “YES”
Drive a short distance.Play the steering free play and keep the steering straight ahead.
The Zero Position Of G85-Steering Angle Sensor is OK
Then clear DTCs.
More Launch X431 Training article,please check here:Launch X431 user guide
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…