Categories: Auto Repair

Audi A8L EPC and Check Engine Light On:P2070 & P1054

A Audi A8L made 2014 with 70 thousands kilometers,equiped with 2.5 CVBA engine.The owner discribed that EPC light on,shake intermittently when accelerating,accelerate slowly, and hard to start.

 

Trouble Diagnose:

Technician found two trouble code by VAS6150.

P1054:Secondary Air Injection Pipe Malfunction

P2070:Intake Manifold Tuning Value Stuck Open Bank

 

Firstly,check the trouble code P2070:Intake Manifold Tuning Value Stuck Open Bank

  • Check the intake air control valve,it is normal.
  • Vacuum solenoid valve work correctly.
  • Auto water pump was damaged.

 

Technician found variable intake flaps work correctly after replacing a new water pump,and P2070 trouble cleanning.

 

Next,technician checked the trouble code P1054,below show the circuit diagram.

Technician detected the voltage between cam control valve connector 1 and GND,it is 0 V(error),but the voltage between N319 connector and GND is 12.Check the diagram,it shows that N208 and N319 are supplied by the same one power.It mean there is a open circuit.

 

How to Solve?

P2070:Replacing a new water pump.

P1054:Fix the wire

auto

Recent Posts

Doosan Stage V Engine U02A2 Timeout Error of CAN-Receive-Frame A1DEFI Solution

This instruction show you guide on how to repair Doosan stage V engine U02A2 timeout…

2 days ago

How to Solve Doosan Stage V Engine P011E Coolant Temperature Plausibility Fault

Here is the instruction show you guide on how to repair Doosan stage v egnine…

5 days ago

How to Use JPRO Diagnostics Performance Check Low Temp ATD Detroit Engine

This instruction show you guide on how to use JPRO Diagnostic software to performance check…

1 week ago

Scania Truck ALM 000800 Interrupted LIN Communicatin Siren

Scania Truck ALM 000800 Interrupted LIN communication with the siren.   Error identification LIN communication…

2 weeks ago

How to Solve JCB Excavator P0615-13 Starter Relay Open Circuit Error

Here is the instruction show you guide on how to solve JCB excavator P0615-13 trouble…

2 weeks ago

Scania Truck ALM 000463 Motion and Inclination Detector,Calibration Fault

This instruction show you guide on how to solve Scania truck motion and inclination detector,…

4 weeks ago