Categories: Auto Repair

Autel MaxiSys MS908 Initialize Window Regulator for BMW E90 328 2006

In this guide,car-auto-repair.com will show you the procedures on how to use Autel MaxiSys MS908 to initialize window regulator for BMW E90 328 2006.In this example BMW rear right window does not work.After replacing window regulator,it can not go all the way up and down.So we need to initialize the window regulator.More BMW Repair case,check here:BMW Repair

 

And this procedures also compatible on Below BMW models:

BMW E90 E92 E93:316i 318i 320i 325i 328i 330i 335i 320d 330d 335d

 

Procedures:

Connect Autel MS908 to BMW E90 obd port,then enter menu to select “Diagnostics”

Select “Auto detect”

Wait for scanning

After VIN scanning,please check and then click “OK” to continue

Click “Yes” to continue (sometime it will show different,but just ignore)

Reading control-nit information

Select “Hot Function”

Select “Window,door and..”

Select “Initialise window regulators”

Just follow the guide to switch ignition

Click “Yes” to continue

Select “Passenger’s side,rear”

It will prompt you with massage:

Do you want to start the initialisation of the power window on passengers side,rear?

The window will be opened and closed

Caution-Risk OF INJURY

The anti-trapping mechanism is NOT active during initialisation

Click “Yes”

Once the initilisation procedures is complete,check whether you can open and close the window on the passenger’s side,rear in automatic mode without a fault occurring..

Click “Continue”

After initialization complete,the dashboard will show status normally,and try to test rear right window work status.

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

2 days ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

4 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

7 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago