In this instruction,car-auto-repair.com will show you guide on how to use AVDI diagnostics to do all keys lost programming for Ford S-Max 2015+.
Procedures:
Connect AVDI programmer to Ford S-Max OBD port
Starting the Abrites Diagnostics for Ford software
Then select “Special Function”–>”Key Learning”
Select “Ford Europe”–>”2015 S-Max”–>”2.0 TDCI”
Select “Erase All Smart Keys”,then click “Execute”
Close all vehicle doors
Switch the ignition ON
Press OK to continue
Close all vehicle doors
Insert the key you want to program in emergency slot.
Switch the ignition ON
Press OK to continue
Note:When erasing the keys,you could ignore the message telling you to insert the keys in the emergency slot and insert them at a later stage during the programming.
Erasing the keys will take a while…
Number of keys programmed:0
Turn ignition ON with the key you want to program or insert it in emergency slot.
Note: This is the step where you program the new keys after the old ones have been erased.
The minimum programmed keys for Ford/Mazda is two.
Put key in slot on steering column.
Slot is under rubber covering at the bottom of the cup holder.
One key is now programmed,insert the second key into the slot
Just repeat the step to program second key,then click “No” exit programming step.
Switch the ignition OFF
Remove the key from ignition switch
Press OK to continue
Operation Successfully
Now test you new keys.
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…