Bendix EC-60 EC-80 Yaw Rate and Lateral Accel. Test and Calibration
The Yaw Rate and Lateral Accel. Test and Calibration is available on:
✓ Bendix EC-60 Advanced braking systems
✓ Bendix EC-80 ESP/ESP+ braking systems
This test checks the calibration of the Yaw Rate/ Lateral Acceleration sensor when the vehicle is stationary. It also provides the ability to recalibrate the sensor if its values are found to be out of bounds.
Related Contents:
2024 JPRO Noregon Commercial Fleet Diagnostics Free Download
Procedures:
1 Select the Yaw Rate and Lateral Accel. Test and Calibration and press Enter or the Start button.
2 The test dialog will be displayed.
3 From the Sensor Readings tab observe the monitored data values and compare them to the defined acceptable ranges. Select the Graph tab to view a graph of the monitored data values.
4 Select the Calibration tab to perform recalibration of the Yaw Rate/Lateral Acceleration sensor. Important test information is displayed for review. Select the Next button to continue.
5 Click the Start button to begin the recalibration.
6 When recalibration begins the test information will be replaced with a fault display for related braking system faults. When calibration is completed a success message will be displayed. Click OK to dismiss this message.
7 If desired the recalibration can be performed again by clicking the Rerun button to return to calibration instructions.
8 When done, press the Exit button to return to the test selection dialog.
More topics about JPRO Diagnostic,please refer to:JPRO Diagnostics Guide