Benz E260 A28600 DTC Front Camera Calibration by Launch X431 ADAS

Sometime when your Benz get A28600 trouble code,it mean you camera need to be calibrated.So here i will show you guide on how to use Launch X431 device to do front camera calibration for Mercedes Benz E260.More Launch X431 feedback,please refer to Launch X431 Feedback

 

Preparations:

2021 LAUNCH X431 PRO3S

X431 ADAS Mobile Kits

 

Procedures:

Connect Launch X431 device to Benz car,then run access menu

Select “ADAS” in main interface

Select “ADAS Calibration”

It will identify VIN code automatically,it will ask you to switch ignition ON

Select “ADAS system scan” at left side menu

Press “Start scanning”

A28600:The calibration of the control unit has been lost or was not carried out.

Press “Enter” and select “Special Function”

The fault memory is erased before calibration is performed.

Press “OK” to continue

Start ADAS Mobile equipment operation

The following tools are required

Select the car models target “ADAS Mobile”

Determine point A and point B

Place calibration equipment according to software prompts

Connect point A and point B to determine the vehicle center line P

Determine point C

Place and adjust ADAS Mobile

Adjust ADAS Mobile to be parallel to the vehicle

Set the height

Select the car model target

 

Press “Input Value”,300mm

 

Then press F3 to continue

Press “YES” to process calibration

Done,you can back to check whether the fault is cleard.

More Benz repair cases,please refer to Benz Trouble Repair