Categories: Auto Repair

Benz E300 W212 Xenon Headlamp Calibration C156E00 by Launch X431

This instruction show you guide on how to use Launch X431 to calibrate Xenon headlamp for Benz E300 W212 C156E00 DTC:Calibration of the vehicle level was not performed.

 

Preparations:

Launch X431 V Pro or Launch X431 PAD V (Amazon Official Shop)

 

Procedures:

Connect Launch X431 V PAD to Benz W212

Run software and select “Local Diagnose”

Select “Automatically Search”

Check vehicle information and click “YES”

Switch On Ignition

DTC detail description

Select “Special Function”

Select “Calibration processes”

Check your vehicle information and click “YES”

Select “Zero Position Adjustment”

 

Requirements:

The vehicle must be at a standstill.

The vehicle must be unladen.

The vehicle must be on a level surface.

The actual values of the level sensors must be in the valid range.

Press “F3”,Start zero position adjustment

After then back menu and select “Clear Fault Code”

Now error message disappear

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

1 day ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

3 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

6 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago