Benz ME 9.7 ECU & 722.9 TCU Reset by Launch X431

It is necessary to reset/virgin used ECU/TCU to install it on another Benz car.So here car-auto-repair.com show you guide on how to use Launch X431 device to reset immo data for Mercedes Benz.More topic about Benz,please refer to:Mercedes Benz Trouble Repair.

 

Launch X431 device used in this case:

Launch X431 PAD V and Launch X-PROG 3

 

Procedures:

Power Launch X431 PAD V,select “Benz software”

Select “Anti-theft Function”

Follow the picture to build connection between Launch X431 device

Select “ECU Erasing”

Here for ECU and TCU list,select “ECU”

Select “Wiring Diagram”

Select “ME9.7”

Follow the instruction to build wiring to ME 9.7 ECU

 

Back to menu,select “Completely Erase Module”

Click “OK” to make backup

Then click “YES”

Erasing Module in Progress

After erasing done,please check information

The steps for ECU or TCU are same.After clear the ECU or TCU,you can use them on other cars.

And after installation,you need to programming/coding or personalize them.

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

1 day ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

3 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

6 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago