Categories: Auto Key Program

BMW BDC All Key Lost Programming by VVDI2

This article show a step-by-step guide on how to use Xhorse VVDI2 to do BMW BDC all keys lost programming.And if you want get more about BMW locksmith tips,check here:BMW Key Programming

 

What You Need?

Xhorse VVDI2 Programmer

VVDI Programmer

BMW FEM/BDC BMW F20 F30 F35 X5 X6 I3 Test Platfor

 

Procedures:

Connect the BDC with test cable

First,click to read key information

Then go to the preprocessing option to read and save the encoding file

Now you need to disassemble the BDC module

Note:Before you start disassemble,you would better to take photos to record the location of the fuses.

Use VVDI Prog to read out data,use the adapter to read 95256 data (if the reading is unsuccessful,try again and again)

You would better to try read data many times (verify that the data is read correctly)

Use Hex Workshop to Verify the consistency of the data that is read more than once

Open VVDI2 BMW software

If the data is correct,the next step is to be done!

Enter the preprocessing option

Generate service pattern data

Save the service schema data and prepare to write to the BDC

Load the service schema data and write data using the VVDI Pro adapter (if the write is unsuccessfully,please try again)

Read the data again and compare it to the previous data.

If the data is consistent,there is no problem writing data,and you can prepare for the next step

 

Programming BDC

Read out the data to compare with the original data(if the data is consistent,prepare the next step)

Restore coding data

After restore coding success,prepare match key

Select the location of the key and prepare to match

Using the programmer to read the engine data,and record ISN

Generate the dealer key with the ISN,insert the key into ignition coil

Input ISN,then it will start programming key.

After programming keys completely,you can test the key on your vehicle.

Done!

 

More about BMW All Key Lost Programming here:

http://www.car-auto-repair.com/tag/bmw-all-key-lost-programming/

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

21 hours ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

3 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

6 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago