Auto Repair

BMW TCU 8HP Gen3 Read Write by Launch X431 X-PROG3

This instruction show you guide on how to use Launch X431 XPROG 3 programmer to program/read/write BMW 8HP Gen3 TCU.

 

Tools you need:

Launch X431 X-PROG3 Programmer

 

Procedures:

Run X-PROG3 software,then input 8hp gen to search

Select “BMW”à”6 Series2018”à”B47D20 1998 190”à”8HP Gen3”

Select “BENCH” and click “Next”

Select “Direct connection of diagram”

Follow the diagram to build connection

There are two methods to connect

1 read in the car directly

2 remove TCU and connect on bench

Click “Connect” button

After then you will find 4 options available

“Read MAP Data” “Read EEPROM Data” “Write MAP Data” “Write EEPROM Data”

Mare sure to backup file before you do clear data.

More test report about Launch X431 please check:Launch X431 Test Report

auto

Recent Posts

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

1 day ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

4 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

7 days ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago

How to Adjust Cruise Control Release Linkage for Kubota L3901 Excavator?

This is instruction show you guide on how to adjust cruise control release linkage for…

3 weeks ago