For BMW X-series X3_E83, when replacing steering angle sensor, fault code of 5EBE steering angle sensor implausible occurs. After checking or replacing the steering angle sensor, first set code for steering angle sensor, then enter ABS/DSC system to calibrate. Save current steering angle value as ZERO.
Another article:BMW X3 E83 Steering Angle Learning by Launch X431
And for more Launch X431 Test Case,check here:How to use Launch X431
Recode:
1.Select Coding/Program.
2.Select car model: Coding/Program, X-series -> X3_E83 Chassis.
3.Select Coding(Recoding).
4.Select corresponding system, such as LWS (steering angle sensor).
5.Steering angle sensor calibration.Select car model: Manually select: System select -> X-series -> X3_E83 Chassis, automatically read out: vehicle identification -> automatic identification -> system scan.
6.Enter ABS (Anti-lock Brake System – DSC) system.
7.Read DTC.
8.Clear DTC.
9.Select Special Function
10.Enter “Steering angle learning”.
11.Follow the software prompts. After successful calibration, it prompts as below:
Fault in the steering angle sensor memory will be automatically deleted after successful calibration.
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…