Bobcat Engine ECU Reset 0 and Reset 1 Fault Code P16C0 P16C2 Solution

This instruction show you guide on how to repair Bobcat engine ECU reset 0 and reset 1 fault code P16C0 and P16C2.

 

Related Contents:

Bobcat Engine Analyzer ECU DCU 2023

2023 Bobcat Service Analyzer 91.15 91.05 Diagnostic Free Download

 

 

1) Overview

U105645-13

  1. Electric problem (Abnormal engine shut down (The battery is removed at engine running or ignition on condition, Battery out<6V))
  2. Electric problem (Wiring harness related DCU power and ground, DCU connector
  3. Electric problem (DCU)

 

 

U105644-13

  1. Electric problem (Abnormal engine shut down (The battery is removed at engine running or ignition on condition, Battery out<6V))
  2.  Electric problem (Wiring harness related DCU power and ground, DCU connector
  3. Electric problem (DCU)

 

 

2) Component Location

Bobcat Engine ECU Reset 0 and Reset 1 Fault Code P16C0 P16C2 Solution

 

3) Condition for Running Diagnostic
Engine Key on or engine running
4) Condition for Setting the Fault Code
The evaluation of the reset reason will be done after every reset. Depending on the configured visibility of the current reset one of the fault checks in the array will be set.
5) Condition for Clearing the Fault Code
When the detected reset was no trap and no software reset all fault checks will be cleared.
6) Check List

Step Inspection Standard
Value
YES NO
1 P16C0/P16C2 is detected on diagnostic tool? Step 2
2 Turn off the Key switch and DCU power. (after Key Off,
please wait for 30sec)
Step 3
3 After Key On, check the fault state.
Is this fault detected continuously?
Step 4 Problem solved
4 Check the DCU voltage related pin connection and
harness.
Pin or connection problem?
Do necessary
repair
Replace
DCU

 

More repair topic for Bobcat,please refer to:Bobcat Excavator Repair

Visited 1 times, 1 visit(s) today