Auto Key Program

Cadillac SLS Key Programming by Launch X431 IMMO PRO

Here is the instruction show you guide on how to use Launch X431 IMMO Pro to do key programming for Cadillac SLS.

 

Device Requires:

LAUNCH X431 IMMO Pro (Amazon Official Shop)

 

Procedures:

After connection build,select “Key Programmer”

Note:before operation please go to Update list to check if your software are the latest version,just update it.

 

Then back to “Key programming” menu

Select “Read Transponder”

Put the original car key next to the key programmer to identify the chip information

Then click “Read Transponder”

 

Record the original car key information,IMMO Type  Transponder46

Back to “Key programming” menu to select “Frequency detection”

Put original car key the programmer,then press key remote control button to identify the key frequency

Back to “Key programming” menu to select “Vehicle Remote”—>“Cadillac”à”SLS”

Put the key machine into the key programmer to generate the key

 

Click “Generate”

Burn successfully

 

After generating the key,open the anti-theft software to increase the key

Go to main menu to select “IMMO”à”GM”à”Anti-Theft Key Matching”à”Cadillac”à”2009”à”SLS-D(VIN4)”à”Immobilizer Key Matching (Intelligent Key)”

Select “Intelligent Key Matching”

It will ask you to Turn off ignition and Turn ON hazard warning lamp

Wait processing

At this time,the immobilizer should be able to accept new remote control keys.

Operate carefully as follows step,click “OK”

1 Turn off the Hazard warning Lamp and Disconnect the test tool

2 Turn the key in the driver door or Trunk lock to unlock for 6 times

3 Learn Remote control keys according to the prompt ON the instrument panel

Program Completed

Now all done,test it on your car.

More test report about Launch X431 please check:Launch X431 Test Report

auto

Recent Posts

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

24 hours ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

4 days ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago

How to Adjust Cruise Control Release Linkage for Kubota L3901 Excavator?

This is instruction show you guide on how to adjust cruise control release linkage for…

2 weeks ago

How to do Perform Cylinder Cut-off Test for Massey Ferguson Tractor

This instruction show you guide on how to use AGCO EDT diagnostic software to perform…

2 weeks ago