Here show you guide on how to replace engine coolant temperature sensor for Chevroelt Avio. More repair case for Chevrolet,please refer to Chevrolet Trouble Repair
Related Contents:
GM EPC GMIO GMNA General Motors EPC 2021 2017 Free Download
GM GDS2 2019 v20.3.05100 Software Free Download
Procedures
Remove procedures
Note: Use care when handling the ECT sensor. Damage to the sensor will affect the proper operation of the fuel injection system.
1.Relieve the coolant system pressure and remove the coolant.
2.Disconnect the battery negative cable.
3.Disconnect the engine coolant temperature (ECT) sensor connector (1).
4.Carefully remove the ECT sensor (2).
Installation Procedure
1.Install the ECT sensor (2) and tighten to 17.5 N·m (12.9 lb ft).
2.Connect the engine coolant temperature (ECT) sensor connector (1).
3.Connect the battery negative cable.
4.Fill the cooling system.
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…
This is instruction show you guide on how to adjust cruise control release linkage for…