This article show a Launch X431 test on Chrysler 300 2013 electronic throttle control system reset/learning processing,it will learn TP Voltage and AP position.
Procedures:
Connect Launch X431 to Chrysler 300,then enter the menu to select “Chrysler V31.00”
Note: This software can diagnose the elec. Control system of Chrysler,Dodge,Jeep.The operation is the same as the original scan tool.
Select “16 PIN Connector”
Select “Manually Select”
Select “Chrysler”
Select “2013(VIN 10th)”
Select “”300”
PCM(Powertrain Control Module)
Select “Special Function”
Select “Learn ETC”,it will learn TP Voltage and AP position.
Press and hold accelerator pedal to the floor.The throttle must be held to the floor.
Release accelerator pedal and press “OK”
Don’t touch the accelerator pedal
The the electrical throttle learn has completed,please log out.
Done!
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…
This is instruction show you guide on how to adjust cruise control release linkage for…