CNH EST DPA5 Diagnostic Adapter Firmware Update Guide

CNH EST diagnostic software will prompt you to update firmware if your CNH DPA5 adapter firmware with old version when you connect it to PC and machine.So here car-auto-repair.com show you guide on how to update firmware for CNH DPA5 adapter.

 

Preparations:

2023 CNH EST 9.8 9.2New Holland Diagnostic Software Free Download

CNH DPA5 Diagnostic Kit

 

Procedures:

Notice:Only high quality CNH DPA5 adapter support firmware update,some fake version can not update,it will prompt error during updating.

Below picture show high quality CNH DPA5 adapter PCB

This software in your DPA5 protocol adapter must be updated before you can use the EST.

This will take about two minutes to complete.The EST will restart automatically after the update

Please click on OK to update the DPA5 now.

Now update processing

Do not disconnect power until update is completed.

 

Your firmware has been successfully updated.

You may now reconnect to your application

CNH EST diagnostic software show hardware and software version information after updating.

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

1 day ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

3 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

6 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago