In this instruction,car-auto-repair.com will show you guide on how to use Launch X431 IMMO Pro to clone DELCO E39 ECU.
Device Requires:
LAUNCH X431 IMMO Pro (Amazon Official Shop)
Procedures:
Select “Engine”à”DELCO”à”E39”à”View Wiring Diagram”
Please connect ECU to the diagnostic connector according to the diagram
Press “Connect”
Press “Backup Complete Data”
Reading Flash data
Data backup successed,you need save it.
Now disconnect and connect new ECU to diagnostic adapter
Then press “Connect”,and press “Restore Complete Data”
Select the file saved from previous ECU
Writing FLASH Data
Data successfully restored!
More test report about Launch X431 please check:Launch X431 Test Report
This instruction show you guide on how to use JPRO diagnostic to do SCR performance…
Here is the instruction show you guide on how to remove and disassemble master cylinder…
This instruction show you guide on how to solve Deutz EMR engine 71 / 2791 /…
Here is the instruction show you guide on how to repair P0731 incorrect 2nd gear ration…
Here is the how to use guide on Caterpillar machine misfire detection test by CAT…
On the Trucktool diagnostic software Settings view, you can edit single parameters, import and export…