This mini post show a guide on how to use DS150 to diagnose Audi A3 2009 to check CAN communication gateway real-time data.And you can check the video guide at end of article.
More Delphi DS150E Project Here:DS150E Test Cases
Procedures:
Connect Delphi DS150E interface to vehicle,then run Delphi DS150E software
[Audi]–>[A3]–>[2009]–>[Multifunction]–>[Gateway]–>[Diagnose],then click “OBD” button at right low corner.
Click [OK] to continue
Communication established
Choose function by using the buttons in the left menu
Tip:
Move the mouse pointer over the buttons to see a hint describing the function
Click “Real-time data” button
Now the Real-time data show as below:
It show from “Data list 1” to “Data list 2”….
You can click “Next” button to view more control module status
Transport mode
CAN:communication,gateway
Done!
This instruction show you guide on how to solve Caterpillar C9 engine injection actuation pressure…
Here is the instruction show you guide on how to remove HV battery cooling fan…
Here is the instruction show you guide on how to solve Scania truck alarm system…
This instruction show you guide on how to repair Doosan stage V engine U02A2 timeout…
Here is the instruction show you guide on how to repair Doosan stage v egnine…
This instruction show you guide on how to use JPRO Diagnostic software to performance check…