Here show you step-by-step guide on how to use Launch X431 to program remote key for Dodge Stratus 2005.This device support erase previous remote control key and new key adding.For more Dodge project,please check here:Dodage Trouble Repair.
What You Need?
Precautions:
1.The battery voltage remains adequate.
2.The key needs to be turned to ON.
Operation Procedures:
1.Select Dodge Software V30.30 or above;
2.Select the 16-PIN connector;
3.Select Manual Select
4.Select Dodge
5.Select 2005(VIN 10th)
6.Select Stratus
7.Select BCM
8.Select “special function”
9.Select the Program Remote Control Key function
10.Observe the description of the Program Remote Control Key function, and prepare the keys to be programmed
11.Operate according to the hints, and press the Lock button and the Unlock button simultaneously and hold to program
12.After confirmed, it indicates Completed. Press the remote Lock and Unlock buttons. If the door lock motor responds normally, the matching is successful.
More test report about Launch X431 please check:Launch X431 Test report
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…