This post show you guide on how to use Autel MX808 to perform DPF regeneration for Ford F350 super duty.More Ford repair cases,please check here:Ford Trouble Repair
Preparations:
Park vehicle with parking brake
Procedures:
Connect Autel MX808 to Ford F350,then select “Service”
Select “DPF”
Select “Hot Function”
Select “DPF(Diesel Particulate Filter) Manual Regeneration”
This procedures will command a DPF(Diesel Particulate Filer) regeneration
Perform the function as recommended in the service manual procedures.
Note:Manual DPF(Diesel Particulate Filter) regeneration may take up to one hour to complete
This test will increase the engine speed to a high RPM(Engine RPM) for an extended period of time.
Press “Yes” to continue
Select “F-350”
Now make sure met below conditions:
Vehicle is not moving
Vehicle is in PARK
Parking brake applied
Follow engine or crank for 5 seconds if engine does not start.
Note:Do not depress the throttle pedal.
Then Autel MX808 will show the DPF regeneration proceed as below
Just wait for DPF regeneration done.
Once the regeneration has been completed,the engine will return to the normal rpms.
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…