After TMPS sensors replacement,you will get error message “Tyre pressure sensor malfunction” on dashboard,now you need to perform TPMS sensor learning for your Ford Mustang.In this post car-auto-repair.com show you guide on how to use Launch X431 device to do TPMS sensor learning.
Preparations:
Launch X431 PROS Amazon
Launch X431 TSGUN with TPMS Amazon
Procedures:
Use Launch X431 Pro to perform a full diagnose for Ford Mustang
Trouble code found B124D
Go to special functions to select “TPMS sensor training mode”
Car will horn while enter to training mode
Select “TPMS” on Launch X431,select your car models
Use X431 TSGUN to do learning for 4 sensors
Car will horn while success learn the sensor
After all done make a test drive the sensors will work well.
More test report about Launch X431 please check:Launch X431 Test Report
It is necessary to do driver installation for JCB DLA 2.0 diagnostic kit,otherwise it can…
Here is the instruction show you guide on how to solve Deutz EMR3 engine fault…
This instruction show you guide on how to solve AGCO machine trouble code 138 SPN…
Here is the instruction show you guide on how to install the left-hand drum bearing…
This instruction show you guide on how to remove and replace loader lift ram for…
This instruction show you guide on how to solve Caterpillar C9 engine 31 84-1 fault…