Some my blog reader don’t like the double honk that occurs when you get out of the truck,so here i want to share the guide on how to use FORScan software to disable Double Horn Honk for Ford F150 EcoBoost.
Preparations:
FORScan Android/iOS/Window Free Download
How to Install & Configure FORScan for OHP ELMconfig
Procedures:
Connect your FORScan device to vehicle,open FORScan software then click the button “Connect to vehicle”
Then it will prompt you with the feedback information,just click “Yes” to continue
FORScan will show the Ford F150 module system information on the log
Click the “Configuration and Programming” on the menu
Select the Body Control Module,then click “Run Service procedure”
Then it will show the warning massage,just click “OK” to continue
FORScan will read the bocks information
After then scroll down to locate “726-41-02”
You need to change the value from “0001 0001 0173” to “0001 0001 0173”
Then click “Save to ECU”
It will prompt you with the warning massage,click “Yes” to continue
Now it prompt you the Blocks programming successfully,pleaes cycle the ignition OFF an then back ON.
Done!
Click “OK” then stop the service procedure and click the button at right low corner to disconnect the software to exit.
This instruction show you guide on how to use JPRO diagnostic to do SCR performance…
Here is the instruction show you guide on how to remove and disassemble master cylinder…
This instruction show you guide on how to solve Deutz EMR engine 71 / 2791 /…
Here is the instruction show you guide on how to repair P0731 incorrect 2nd gear ration…
Here is the how to use guide on Caterpillar machine misfire detection test by CAT…
On the Trucktool diagnostic software Settings view, you can edit single parameters, import and export…