This instruction show the guide on how to use G-scan 2 diagnostic tool to initialize power window regulator for BMW X3 F25 2015.And for more G-Scan 2 test report,please check here:G-Scan 2 Test Projects.
Procedures:
Connect you G-scan 2 diagnostic tool to BMW X3 F25 2015 by OBD port,then access [DIAGNOSIS] to select vehicle.
BMW–>X SERIES–>X3(F25)(2010-present)–>Body system–>FRM
Then select [OK] to continue
Go to [Special Function]
Select [Initialise power window regulators]
You can initialise the power windows as follows using the diagnostics procedures.
Connect the battery charger to the vehicle before performing the initialisation.
Close all vehicle doors
The relevant power windows is activated during initialisation.
The power windows will be denormalised and subsequently reinitialised
Initialisation status:
Driver’s side:Power window regulator-Normalized
Passenger’s side:Power window regulator-Normalized
Rear driver’s side:Power window regulator-Normalized
Rear passenger’s side:Power window regular-Normalized
Select power window regulator:
Note:Close all door to initialise the power window regulators
Here we select F6:Rear driver’s/passenger’s side
Do you want to start the initialisation of the power windows regulator?
The window will be opened and closed
CAUTION -DANGER OR INJURY
The anti-trappig mechanism is NOT active during initialisation.
Select [OK] to continue
The initialisation procedures has started
The window will be denormalised and subsequently reinitialised
Now initialization procedure has been started
Once the initialisation procedure is complete,check whether you can open and close the window in automatic mode without a fault occuring (one-touch control function)
After initialization is all done.Select OK to finish.