Categories: Auto Repair

G-scan2 Initialize Adaptive Values for Citroen C3 2017

This function resets all adaptive values in an engine and it needs to be performed when sensor related repair or part replacement is done to an engine.

 

Procedures:

Connect G-scan2 to vehicle by OBD port,enter menu to select “DIAGNOSIS”

Select “CITROEN”

Note:Automatic selection is added in 2019 January update.

Select “C3(A51)(2013-)”3

It show the vehicle information:VIN,MODEL,ENGINE and YEAR

Select “Special Function”

Select [Initialization of the autoadaptive values]

Make sure to meet the precondition described in the beginning of calibration:

IG ON

The fan assembly should not be operating

Do not start the engine for 10 minutes before performing this operation

The air conditioning must be OFF

The battery voltage must be above 12V

Switch off the ignition

It will take about 1 minute to perform

Note:This part is edited for 5 times faster than original footage

Operation completed

Switch off the ignition and switch it on again

Done!

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

2 days ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

4 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

7 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago