Categories: Auto Repair

G-scan2 Perform EGR Test for Honda VEZEL Hybrid 2015

This article show the operations of how to use G-Scan2 to perform EGR test for Honda VEZEL hybrid 2015.Note,if your software is outdated,this function is not available,you need update your software to the latest version.

 

Video Guide Here:

Procedures:

Connect G-scan2 diagnostic to Honda VEZEL hybrid,then enter menu to select “DIAGNOSIS” option.

Select “HONDA” vehicle model,then select “Automatic selection”

Note:Automatic selection is added in 2019 January Update.

Show the vehicle model information as below:

You also select manually

Select [HONDA]–>iNTERNATIONAL–>16 PIN–>CONNECTOR–>Engine

Select “Special Function”

Select “EGR Test”

Activates the EGR value

First,reads the input voltage from EGR valve position sensor and detects a short or open.

Next,activates the EGR valve and monitors the response time in order to detect a “stuck” or a “slow response of valve”

It is normal if response time is within 3 seconds on the “open side” and it is within 2 seconds on the “close side”./

 

TEST CONDITIONS:

Shift Position:N or P

Vehicle Speed:0 mile/h

A/C Switch:OFF

Check the test condition before pressing “OK”

Follow the operation instruction

Start the engine

Please Keep the engine speed below 1500 RPM

 

Stabilizing,please wait…

 

Turn off all electrical devices

Centre the steering wheel

Do not move the steering wheel during testing

This time,keep the engine RPM between 2500-3000RPM

Now Testing

Please hold the throttle steady

Engine Speed:2713RPM

EGR Lift Sensor:3.18V

Open Response:SUCCESS

Close Response:SUCCESS

It show the test result!

System is Normal.

 

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

14 hours ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

3 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

6 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago