This article show a guide on how to use G-Scan2 to perform throttle valve stp learning and resetting the cold start adaptation value for Mercedes Benz S-class 2011.At end of article you can check the procedures by watching viedeo guide.
And for more G-scan2 Test project check here:G-scan2 Test Cases
Procedures:
Connect G-scan2 to your Benz S-class,and enter menu to select “Diagnosis”
Select Benz vehicle model
“ME/CDI/CNG-Enigne control unit”à”S-class”,click “OK” to continue
Select “Special Function”
Scroll down the bar to select “Throttle valve stop learning”
Preconditions:
Ignition ON
Engine stop
Coolant temperature between 5℃(41℉)and 8℃(176℉)
Intake air temperature less than 40℃(104℉)
Acceleration pedal must not be operated
Vehicle stop
No DTC on the Traction system
The engine must be stopped for longer than 1 min
Press [OK] to start
Note:Turn ignition off
Press [OK] to next
Note:Turn ignition on
Press [OK] to next
Note:Complete
Press [OK] to exit
Select “Resetting the cold start adaptation values”
Note:
Ignition ON
Vehicle stop
Engine stop
Selector lever in position P/N
Coolant temperature between 5℃(41℉)and 8℃(176℉)
Acceleration not operated
Press [OK] to exit
The following functions are performed:
The cold start adaption is reset
Press [OK] to start
Note:
Turn ignition off
Press [OK] to next
Note:Turn ignition on
Press [OK] to next
Note:Complete
Press [OK] to exit
Done!
Video Guide:
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…
This is instruction show you guide on how to adjust cruise control release linkage for…