This instruction show you 2012 GM Cherolet Orlando performing Diesel Particulate Filter(DPF) service regeneration with G-scan3. If you want to know more about DPF, please refer to Diesel particulate filters projects.
Connect G-Scan3 to Cherolet Orlando obd port, then enter menu to select “Diagnosis”
Select “GM”–> “AUTOMATIC SELECTION”
Select “Powertrain”
Select correct type of the engine and hit “OK”
Select “Special Function”
Scroll down and search for “DPF Service Regeneration”
Read the description carefully, then hit “Ok”
Please note: The ECT Sensor must be 75 deg. Of Cor higher, otherwise the function will not start.
Go to “Data Analysis” and check “ECT Sensor” value
Function will be completed when the engine idle returns to normal. Hit “OK” to proceed.
RPM will be increased to ~2000.
Function may take up to 20 minutes and when it’s completed, RPM will be turned to normal idle position.
Current status of DPF Soot Mass will be displayed along with the engine RPM.
As soon as the DPF Soot Mass reaches 0%, RPM will drop to normal idle position.
Function is completed. Hit “OK” to exit.
If you want to know more about Chevrolet Repair cases, please visit Chevrolet Trouble Repair.
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…