Heavy Equipment Repair

HINO J05E Engine 2018 P0005 Trouble Code Repair Guide

It is an illustration on how to repair HINO J05E engine 2018 P0005 trouble code:Fuel cut valve stuck closed.

Related Contents:

Nexiq USB2 Diagnostic Adapter

2024.03 HINO Diagnostic Explorer DX3/DX2 Diagnostic Software Free Download

HINO Trucks EPC Electronic Parts Catalog 2018 2016 Free Download

 

 

Technical Description:

1) The engine ECU monitors the pressure in the fuel pipe based on the value of the fuel pressure sensor.

 

Description of Malfunction: .

1) Sticking of the fuel cut valve (FCV) was detected.

 

DTC Set Condition:

1) DTC Detection Condition:

  1. a) The engine revolution is 700 r/min or more.
  2. b) The difference between the actual common rail pressure and the target common rail pressure is 1 Mpa or less.

2) Judgement Criteria:

  1. a) The pressure in the fuel pipe is 0 MPa or less when the engine revolution is 750 r/min, and remains at 0.2 MPa or less for 30 seconds even when the engine revolution becomes 1000 r/min or more.

 

Reset Condition:

1) Immediately after normal status is resumed.

Indication, Warning or System Control Regulation When The DTC Is Set:

1) MIL: ON

2) SVS light: OFF

 

Symptoms on the Vehicle When the DTC is Set:

1) Symptoms On The Vehicle Due To Backup Control (Fail Safe Function):

  1. a) None

2) Symptoms On The Vehicle Due To Malfunction:

  1. a) DPR automatic regeneration may not be performed properly.

 

Pre-Inspection Work:

1) Check that the battery voltage is in the normal range.

After-Inspection Work:

1) Clear all past DTCs.

2) Check that no DTC is detected after test drive.

 

Possible Causes:

1) Power supply for fuel cut valve.

2) Fuel leakage (loose joint bolt), clogging, crush, and wrong assembly in fuel pipe.

3) Defect of fuel cut valve.

 

More case for HINO please refer to:HINO Trouble Repair.

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

9 hours ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

3 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

6 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago