Here is the troubleshooting guide on how to solve HINO J05E engine 2018 P0045 DC Motor Terminal Open Circuit or DC Motor Coil Open Circuit.
Related Contents:
2024.05 HINO Diagnostic Explorer DX3/DX2 Diagnostic Software Free Download
HINO Trucks EPC Electronic Parts Catalog 2018 2016 Free Download
Technical Description:
1) The VNT actuator moves the nozzle vane steplessly by the LEA(Linear Electric Actuator) to control the turbo speed and boost pressure.
2) The LEA has a sensor to detect the movement of the actuator, always monitoring the target and actual value of the nozzle vane opening.
3) Wiping operation is performed while the engine is stopped for the purpose of removing soot and oil coming out from the range of vane operation and checking the turbo mechanical operating range for abnormality.
Description of Malfunction:
1) None
DTC Set Condition:
1) DTC Detection Condition:
2) Judgement Criteria:
Reset Condition:
1) After restoration to normal condition and starter key “LOCK” Indication, Warning or System Control Regulation When The DTC Is Set:
1) MIL: ON
2) SVS light: OFF
3) Engine output is restricted.
Symptoms On The Vehicle The DTC Is Set:
1) Symptoms On The Vehicle Due To Backup Control (Fail Safe Function):
2) Symptoms On The Vehicle Due To Malfunction:
Pre-Inspection Work:
1) Check that the battery voltage is in the normal range.
After-Inspection Work:
1) Clear all past DTCs.
2) Check that no DTC is detected after test drive.
Possible Causes:
1) Faulty contact in VNT controller connector
2) LEA internal disconnection
3) Controller internal disconnection
More case for HINO please refer to:HINO Trouble Repair
This illustration show you guide on how to repair Cummings QSK60 CM2358 engine camshaft speed/position…
Here is the instruction show yo guide on how to solve Fendt MT800E tractor DEF…
Here car-auto-repair.com show you guide on how to solve ISUZU construction 4JJ1 engine P0092 fuel…
Here is the illustration show you guide on how to solve Perkins 1106D electric power…
Here comes the instruction on how to use SerDia2010 to perform assembly inspection and initialization…
This instruction show you guide on how to perform No load max differential pressure measurement…