Truck Repair

HINO L-Series Truck Fuse Block Relay Panel and Fusible Link Block

Location of the Cab Side
The fuse block and the relay panel are located inside the instrument panel as shown below.

 

[NOTE]
Be sure to use each capacity fuse designated in the above table.
Never use the capacity fuse exceeding the designated one in the above, otherwise over current may damage the harness wires and fusible linkage wires.

 

 

Related Contents:

Nexiq USB Link

2024.02 HINO Diagnostic Explorer DX3/DX2 Diagnostic Software Free Download

HINO Trucks EPC Electronic Parts Catalog 2018 2016 Free Download

 

 

Location of the Chassis Side
The fusible link block is installed in left side rail as shown below

[NOTE]
Do not remove the harness connector, fusible link block, and cover except for repair and/or inspection.
If removal is necessary, pay attention that water and/or foreign matter do not attach or enter
the connector, terminals, electric component box, and cover.
If repair or replacement is required, make sure there is no attachment or entry of water and/or
foreign matter. Mount properly to ensure waterproof function is not compromised.

 

DETAIL OF FUSIBLE LINK AND RELAY POSITION

  • How to remove fusible link box cover.
    1. Push lock lever and remove lock. (2 position, marked )
    2. Pull-up 2 position of plate lock (marked ) and remove cover.

More case for HINO please refer to:HINO Trouble Repair

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

19 hours ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

3 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

6 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago