This instruction show you guide on how to repair HINO Truck 600 series P0016 abnormality in phasing by revolution pulsar trouble.
Preparations:
2024.03 HINO Diagnostic Explorer DX3/DX2 Diagnostic Software Free Download
HINO Trucks EPC Electronic Parts Catalog 2018 2016 Free Download
Procedures:
1.Inspect the camshaft gear.
Check that the camshaft gear is properly assembled.
Refer to the section “TIMING GEAR” in the chapter “ENGINE MECHANICAL (J08E)” (S5-CJ08E11* or S5-UJ08E11*).
If you found any failure,assemble the camshaft gear properly,otherwise go to step 2.
2.Inspect the flywheel
Check that the flywheel is properly assembled.
Refer to the section “FLYWHEEL AND FLYWHEEL HOUSING” in the chapter “ENGINE MECHANICAL (J08E)” (S5-CJ08E11* or S5-UJ08E11*).
If you find any failure,assemble the flywheel properly.
Flywheel and flywheel housing
Otherwise go to step 3
3.Inspect Crankshaft position sensor(Engine speed main sensor), Camshaft position sensor
Check that the sensor are installed to the proper position.
If you find failure,install the crankshaft position sensor (engine speed main sensor) and the camshaft position sensor (engine speed sub sensor) in proper locations.
Otherwise procedure completed.
HINO DX2 1.1.21.3+Database 2.3.21.0 Download & Installation Service
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…