Categories: Auto Key Program

Honda CIVIC 2016 Smart Key Rewrite by Launch X431

This illustration show you guide on how to use Launch X431 devices to rewrite smart key for Honda CIVIC 2016.More topics about Honda,please refer to:Honda Trouble Repair

 

Related Device:

Launch X431 V Pro or Launch X431 PAD V (Amazon Official Shop)

 

 

Notes

  1. You must have an original key;
  2. Before performing the operation, ensure that the vehicle battery voltage is not lower than 12V and the device has sufficient power;
  3. Duringoperation, strictly follow thedevice prompts to switch ignition OFF/ON;
  4. During operation, strictly followthedevice prompts to put the corresponding key in or outside the vehicle;
  5. Afterthe operation completed, check whether all the keys normally open and close the doors and start engine normally.

 

Steps

1.Turn off the ignition switch (if the ignition switch has been turned on), prepare all the keys, and connect the diagnostic device, enter the corresponding IMMO module, and select HONDA Anti-theft diagnostic software.

2.Select the menu “Anti-Theft Key Matching”, the software will automatically detect the Anti-theft type and display the corresponding function menu

 

3.As described in above function introduction. Select the function “Rewrite Honda Smart Keys”to invalidate the lost original key.

 

4.Turn the ignition switch to OFF

Note: This operation will be performed more than once during operating, please perform by strictly following the prompts.

5.Take only one original keyless access remote into the vehicle, and remove all other keyless access remotes from the vehicle.

6Turn the ignition switch to ON

7.Enter the number of keys you want to register, that is, the number of all keys except the one lost. Here is an example of keeping only one key

8.Turn the ignition switch to OFF

Note: This operation will be performed more than once during operating, please perform by strictly following the prompts.

9.Turn the ignition switch to ON. Click OK for communicating, please wait for about 10 seconds.

10.Check whether the keyless access remote and immobilizer indicator light goes off.If it is not off, the rewriting failed; if it is off, continue to check whether the key registration is successful

11.Turn the ignition switch to OFF

12.Turn the ignition switch to ON

13.Registration completed. Turn the ignition switch to OFF

 

14.Check the smart key, try to start Engine, lock and unlock doors

15.Turn the ignition switch to ON. Rewrite Smart Keys completed.

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

1 day ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

3 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

6 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago