Honda XRV IMMO light on after replacing ECU (ECU Program)

Here comes this artilce about How to solve Honda XRV IMMO light on after replacing ECU.The Honda XRV SUV made 2015 whose ECU was damaged by accident.And the immobilizer system lights on after replacing a ECU.Here we use Autel MS908 to program new ECU, immobilizer system lights off and we can start the engine correctly at the end.

 

How to program new ECU for Honda XRV?

This trouble occur means: ECU need to progam.

 

Step 1:Connect Autel MS908 to vehicle,and it will read PIN and enter vehicle model automatically.

 

Step 2:Enter “Control Unit”,select “IMMOBI”

Step 3:Enter “Anti-Starter”(show below pic),and select “Replace ECM and PCM”

Step 4:Follow the reminds to turn off the ignition and then turn on.Wait for the screen information “Anti-starter register completely”,then turn off the ignition.

Step 5:Turn on ignition,the program will record the code of anti-starter into immobilizer system.

Note:Befor registering,you need to comfirm all key function work correctly.

Step 6:Turn off ignition when you see the information “smart remote key register completely ”.And turn ignition key again,you will find dashboard light off and you can start engine correctly.

auto

Recent Posts

QSK60 CM2358 Engine Camshaft Speed/Position Sensor Data Erratic Incorrect

This illustration show you guide on how to repair Cummings QSK60 CM2358 engine camshaft speed/position…

5 days ago

Fendt MT800E Tractor DEF Tank Temperature Does Not Change Solution

Here is the instruction show yo guide on how to solve Fendt MT800E tractor DEF…

7 days ago

HITACHI Construction 4JJ1 P0092 Fuel Pressure Regulator Control Circuit High

Here car-auto-repair.com show you guide on how to solve ISUZU construction 4JJ1 engine P0092 fuel…

1 week ago

How to Solve Perkins 1106D EPG Engine E398 Low Fuel Rail Pressure Error

Here is the illustration show you guide on how to solve Perkins 1106D electric power…

1 week ago

Deutz EMR3 Aassembly Inspection and Initialisation Test Guide

Here comes the instruction on how to use SerDia2010 to perform assembly inspection and initialization…

1 week ago

HITACHI ZX-5 Excavator No Load Max Differential Pressure Measurement Guide

This instruction show you guide on how to perform No load max differential pressure measurement…

2 weeks ago