How Setup Your Diagnostic Interface for JPRO Commercial Diagnostics

There are several diagnostic interfaces are compatible with JPRO Commercial Vehicle Diagnostics software.You need setup your diagnostics interface in configuration setting.So here show yo guide on how to set it.

 

Preparations:

2024 JPRO Noregon Commercial Fleet Diagnostics Free Download

Nexiq USB Link 2

 

Procedures:

Run JPRO Commercial Vehicle Diagnostics software,then select “Application Settings”

Then select “Preferences”

Open “Connection” and select “Connect using these settings”

Select “NEXIQ Technologies USB-Link 2” from Vendor list

Select “USB-Link 2” from Device list

Then click OK

After then click “Connect” button on menu

And then select “Heavy Duty” in “Select Connection Type”

Now connection build

auto

Recent Posts

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

2 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

5 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago

How to Adjust Cruise Control Release Linkage for Kubota L3901 Excavator?

This is instruction show you guide on how to adjust cruise control release linkage for…

3 weeks ago