Categories: Odometer Adjustment

How to adjust odometer Toyota Camry by Digimaster 3

Here comes the step by stey guide on how to modify mileage of odometer of Toyota Camry by Digimaster 3.Hope this article is helpful.

 

Step 1:Remove the instrument of Toyota Camry to find out the PCB board shows as below picture.The picture give the location of chip C46,remove chip C46 form PCB board.

The chip C46 appear as below picture.

Step 2:Open “Digimaster 3 vehicle list ” file,then search Camry,you will get information that you need OBP adapter.Find out the OBP adapter in the tool box,then weld C46 chip on the OBP adapter and connect OBP adapter to Digimaster 3.

Note:Weld the chip in the right location as bellow,you need to pay attention to the direction of C46 on the OBP adapter.

Step 3:Open Digimaster 3,select “Meter System” –>Select “Japan & Korea–>Select “Toyota–>Select “Camry”–> Select “C46”

Step 4:In the Digimaster 3, click Next, read out Chip mileage value 80KM, select “Yes” to adjust the mileage value you want.Here we enter 4567, and then click “OK”.

It will remind you “Write Data Succeed”!

Step 5:Remove the chip C46 from OBP adapter,then weld chip C46 back on PCB board you remove from Camry instrument.Restore what you disassemble before.Done!

auto

Recent Posts

QSK60 CM2358 Engine Camshaft Speed/Position Sensor Data Erratic Incorrect

This illustration show you guide on how to repair Cummings QSK60 CM2358 engine camshaft speed/position…

5 days ago

Fendt MT800E Tractor DEF Tank Temperature Does Not Change Solution

Here is the instruction show yo guide on how to solve Fendt MT800E tractor DEF…

7 days ago

HITACHI Construction 4JJ1 P0092 Fuel Pressure Regulator Control Circuit High

Here car-auto-repair.com show you guide on how to solve ISUZU construction 4JJ1 engine P0092 fuel…

1 week ago

How to Solve Perkins 1106D EPG Engine E398 Low Fuel Rail Pressure Error

Here is the illustration show you guide on how to solve Perkins 1106D electric power…

1 week ago

Deutz EMR3 Aassembly Inspection and Initialisation Test Guide

Here comes the instruction on how to use SerDia2010 to perform assembly inspection and initialization…

1 week ago

HITACHI ZX-5 Excavator No Load Max Differential Pressure Measurement Guide

This instruction show you guide on how to perform No load max differential pressure measurement…

2 weeks ago