Categories: Excavator Repair

How to Change Engine Oil & Filter for Volvo EC950E Excavator

This is a service document on how to replace or change engine oil & filter for Volvo EC950CE L excavator.After every 500 hours working,it requires you to change them.More excavator projects,please refer to:Excavator Trouble Repair

 

Notice:

Always handle oils and other environmentally hazardous fluids in an environmentally safe manner.

NOTE!

Drain the oil when the engine is warm.

 

WARNING:

Work carefully when changing oil as hot oil can cause severe burns to unprotected skin.

Risk of burns – stop the diesel engine and allow it to cool down before starting any work.

This instruction include in Volvo PROSIS Offline Parts+Service Manual

 

Volvo EC950E Change Engine Oil & Filter Procedures:

1.Remove the undercover.

2.Open the oil drain valve cap and install the engine oil drain hose and then allow the oil to drain from the engine into a suitable collection container.

3.Change the oil filter using a filter wrench (tool part no.: 9996672), fill the new oil filter with engine oil.

Clean the filter housing base. Make sure all of the old filter gasket is removed.

NOTE!

Apply a light coat of the engine oil to the gasket of the new filter.

Screw the filter in place until the gasket just touches the sealing surface. Tighten another 1/2 turn by hand.

NOTE!

Dispose of waste oil and used oil filters in an environmentally safe manner.

Filling

4.Fill the engine oil through the rocker arm cover cap.

5.Warm up the engine and check that there is no oil leakage.

6.Check the oil level on the dipstick.

7.Install the undercover.

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

2 days ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

4 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

7 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago