How to Clear LED Errors via VCDS for VW

After mounting the LED bulbs on low-beam, high-beam, position lights and fog lights, there is a permanent fault on the instrument dashboard. This is why this coding using the VCDS helps to remove this fault and if one of the bulbs is defective it will be reported.

 

Steps:

Connect VCDS to VW OBD port, and running it.

Click “Select” to select control module

Select “09-Cent. Elect.”

Select “Fault Codes-02”

Default fog- Light and High beam, low beam

Click “Clear Codes -05”

Go back and click “Coding -07”

Click “Long Coding Helper”

Remove tick from Bit 2

Exit, then click “Do It!”

Coding accepted.

 

More cases about VW, please refer to VW Trouble Repair.

Kevin

Recent Posts

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

1 day ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

4 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago

How to Adjust Cruise Control Release Linkage for Kubota L3901 Excavator?

This is instruction show you guide on how to adjust cruise control release linkage for…

3 weeks ago