How to Do Adapt Service Oil and Inspection by VCDS for VW,SEAT,SKODA and AUDI
This short post will show you guide on how to do adapt service oil and inspection by VCDS. More function of VCDS, please refer to VCDS CASES.
This function applies to VW,Seat,Skoda and Audi.
Procedure:
Connect VCDS to vehicle OBD port, running VCDS.
Click “Select” to select control module
Select “17-Instruments”
Select “Adaptation-10”
Input “Sia” for search, then select “IDE01153-SIA: maximum value of distance to service”
New value change to “10000”, click “Do It!”
Old value: 15000km
New value: 10000km
Replace?
Click “Yes”
Controller accepted the request. Will now read the channel again,
Click “Ok”
Select “IDE01154-SIA: maximum value of time to service”, new value change to “180”
Click “Do It!”
Function is ready.
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…