Categories: Do It Youself

How to do an Oil Change for Toyota Camry 2005-2010 by Yourself

In this instruction,i will show you how to change oil for Toyota Camry 2007.This oil change method can apply to 2005 to 2010 Toyota Camrys.

 

What you Need?

Toyota Engine Oil (4 quarts)

Oil Filter

Oil Filter Removal Tools 

Large Multi Purpose Oil Funnel 

Oil Drain Pan

Scott Shop Towels

Jack & Stands Combo’s

 

Procedures:

Locate support bar,and then you are going to put the jack underneath it.

Note:Make sure to pull your E-brake before you jack the vehicle up

 

Then we need o drain the oil,and it need a 14 millimeter wrench,a bucket oil pan

Slide the bucket oil pan under the front of the car

This is what you need to remove on the oil pan.

Now we need to use 14 millimeter to remove the bolt

Let oil drink to bucket oil pan

Unscrew oil pan out

 

Locate the oil filter

Now prepare the tool to remove oil filter:3/8 inch wrench with extension

Put the remove tool adapter on the oil filter,

And you are going to turn it lefty loose

 

Now install the new oil filter

Note:Do not forget to check the old filter to make sure the O-ring is on the filter and not left on the vehicle.Some times they get stuck to the bottom of the oil filter assembly.

Now we need to put oil pan nut back on the oil pan

 

Start filling oil up

After you fill up your oil,just put the oil cap back

And now we are going to check oil on level ground with the dipstick.

After checking your oil on level ground,run the vehicle for 5 mins,turn vehicle off and let sit for 5 more minutes,then recheck the oil again to make sure the levels have not dropped.If they have dropped closer to the bottom line just add more.

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

2 days ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

4 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

7 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago