How to Exchange Engine ECU for Audi by Abrites

This instruction will show the procedure for exchanging an engine ECU by AVDI Abrites diagnostics programmer. If the engine control unit is EDC17/MED17/Simos, you need to use VN004 to read the unit’s PIN and CS in boot mode.

 

Procedure:

Connect AVDI Abrites programmer to Audi obd port, running software.

Select “Audi”

Select “Special functions”

Select “CAN Instrument”

Click “Enter Service Mode by OBDII”

Click “Read Immo data”

Copy CS and PIN number and save it in notepad, named PIN and CS of HOST VEHICLE.

Click “Exit”

Select “Immo parts adaptation”

Click “Engine control unit{EDC16/EDC17/MED9/MED17/Simos”

Select “Specify manually the existing CS/PIN of the engine control unit”, input the old CS and PIN number, and click “Read”

Input new CS and PIN number we saved previous, then click “Update”

Please make ignition OFF for 5 seconds and then again ON. After do that, click “OK”

Function is completed. Exit the software.

If you want to know more cases about AUDI, please refer to AUDI TROUBLE REPAIR.

Kevin

Recent Posts

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

1 day ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

4 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

7 days ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago

How to Adjust Cruise Control Release Linkage for Kubota L3901 Excavator?

This is instruction show you guide on how to adjust cruise control release linkage for…

3 weeks ago