After installation of Xentry diagnostic software,it requires you get StartKey to activate Xentry diagnostic software,otherwise it can not work.Here show you guide on how to get StartKey for Xentry.
Related Contents:
2024.03 Benz Xentry.OpenShell.XDOS Diagnostic Software Free Download
How to Install Benz Xentry 2024.03 Diagnostic Software
Procedures:
ConfigAssist can be located by the following means after Xentry has been installed:
-Search for “ConfigAssist” from the Start Menu Search Bar.
-By using the Start Menu (Windows 7 & Windows 10).
-Windows 7
-Start Menu->All Programs->Mercedes-Benz-> ConfigAssist
-Windows 10
-Start Menu->Mercedes-Benz-> ConfigAssist
The following pages contain information on where to find Startkey information inside the
ConfigAssist application.
1.Run ConfigAssist
2.Select which device you are using. Currently FusoConnect’s and SDconnects are being used.
3.Choose the Configure option on this screen.
4.Locate and click on the lock icon in the bottom area of the application.
5.After a brief loading period the application will try to connect to the Xentry Servers and attempt to download a Startkey if you previously request one. The information MFTA requires
for new Startkey requests is found on the left side of the application (#1). After copying this data, please click the Apply & Continue button in the lower right corner (#2)
6.Click the Check Mark icon in the bottom bar and then click on the Exit button.
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…