Openport 2.0 adapter is capable of communicating with most OBDII compliant vehicle with standard J2534.Here car-auto-repair.com show you guide on how to install and configure driver for Openport 2.0 J2534.
Preparations:
Openport 2.0 driver download here
Procedures:
Connect USB cable to laptop and Openport 2.0 adapter
Then your PC will prompt you find a unknown device
Go to “Device Manager” to check there with a yellow exclamation mark
Double click “openport2_setup_1024791.exe” from download link file
Click “Next” to cotinue
Click “I Agree”
Setup will install OpenPort 2.0 J2534 Drivers in the following folder.(Record the folder driver installed)
To install in a different folder,click “Browse” and select another folder
Here click “Next” to continue
Finish driver installation
Now back to “Device Manager”
Double click “OpenPort 2.0” with yellow exclamation mark
Click “Browse to select local driver”
Now here you need select the driver folder you install before (record before)
Then click “OK” to load driver
After then just wait process
Done
Now back “Device Manager” to check the status,the yellow exclamation mark disappear
Finish!
You can run related software for OpenPort 2.0,like Benz Xentry,MUT-III..
This instruction show you guide on how to perform hydrocarbon dosing control valve test for…
This instruction show you guide on how to solve Fendt tractor SPN 100 FMI 31…
Detroit GHG17 Heavy Duty Engine Piston Protrusion Measurement Procedure Related Contents: 2024.06 Detroit Diesel…
This instruction show you guide on how to remove and install water temperature regulator housing.…
Monza, Kadett and Ipanema Multec 700 GM ECU Components Pinout Vehicles: Monza, Kadett and…
This illustration show you guide on how to remove oil pressure regulation valve for CLAAS…