Be sure to observe the following instructions when separating rear stop lamp and turn signal lamp.
Related Contents:
2024.02 HINO Diagnostic Explorer DX3/DX2 Diagnostic Software Free Download
HINO Trucks EPC Electronic Parts Catalog 2018 2016 Free Download
Add a short pin connector for flasher cutting
• Prepare the short pin below which is available as a spare parts.
Part No. :82235-E0280
• Turn the starter switch to “LOCK” position, wait at least 10 minutes, and disconnect the negative terminal of battery before start work.
• The short pin connector connect to the connector which fixed to the protector.
• The turn stop dual output line of the BCM switches to the stop single output line of the BCM by connecting short pin connector to the connector. •••••
[NOTE]
• Make sure that the short pin connector is connected to the connector.
If the connector is not connected sufficiently, a circuit will return to the original condition.
[CAUTION]
The rear turn lamp connection will be cut out after this modifying, therefore, the following additional modifying is required.
More case for HINO please refer to:HINO Trouble Repair